Recent content by antony23

Any difference with DS-K2M061 or DS-K2M062? I checked them and cannot see any important difference.

Hi, if i use the onboard relay of the DS-KH6350-WTE1 monitor indoor station, could i use the RFID card/key of DS-KV6113-WPE1(C) (installed at oudoor) to act on the monitor's relay?

Hi, in the DS-KV6113, there's a hole on the bottom of the device where the network cable and relay wires can get caught without remove the device. This is the first time I've seen something like this; an intruder could access the relay cables and open the door. Have you noticed this? Is there...

Hi, i installed the KV6113-WPE1(C) and connected its NO-COM relay to a 12V power supply to open my house door. All is working correctly but "Open Duration" is too much, about 2 seconds, so i set it to 1 second in the settings, but this change does not seem to have any edffect, because relay...

Is it G5 platform? Should i read Firmware Version Property to get it?

I cannot send it now, i'm not reach web gui camera now, but yes, configuration is like this. Maybe it is important that i set h265+ coding for main and substream?

I just made it. No notifications sent. But i suspect the detection is not working on the camera, because i cannot see any detection in timeline playback. Do you have a video or guide for help me check my line crossing setup? Can i disabled Motion detection and keep enabled only cross line...

My region is Italy. Should i use firmware from my region or i could use Global EN? Dot you think fw upgrade can fix my problem?

Yes, of course. More, in camera settings of hik-connect app i can see only intelligent detection, and inside only movement detection, if i enabled it trough web gui. Should i see here cross line detection too?

Hi, i setup my first hikvision camera (DS-2CD2346G2-IU), firmware version 5.7.13build 230706. I don't have NVR at the moment, i put an sd card into camera. I added camera to hik-connect portal trough serial number, and i can see camera on my android hik-connect app. On app i also enabled...

Can't zoom via software?

Hi, I just was installing today my first hikvision camera, model ds-2cd2346g2-iu (turret acusense). But, maybe it's not so clear or maybe i'm stupid, but i really don't understand how i should point lens to my desired view. I have to do it manually, that'is "phisically", rotating circle...

Just to understand better, could the hik-connect app only work in LAN without Internet access? Push notifications also work? For remote use, ok, the two options are hik-connetc cloud and remote lan access. Clear.

Can i access nvr, cameras, intercoms and indoor monitors using web interface on browser for configuring and monitoring? Or the only way is iVMS-4200 installed on a PC? For smartphone, the only app is hik-connect? This app access them using cloud or if i "stay" in same LAN cloud is not used?

I also meant NVRs and cameras.I should use iVMS-4200 to configure all stuff?