If there is no hard reset button then the only other option is the SD Card slot or using the serial port. I don’t know how to do the serial port version. Make sure you have the correct firmware for the A series. Honestly it should work. You must be doing something wrong. Put SD card in with...
nope! Just upload the FIRMWARE FILE ONLY to the SD card, no folders or sub folders or other content. Just the single file, place SD card into doorbell, power up and Doorbell will pull new firmware. Once it is complete, it will reboot, at which point, remove the SD card so it doesn’t do the...
So, for example:
virtual host on
NVR assigned static IP: 192.168.1.200
Gateway:192.168.1.1/24
DB assigned static IP: 192.168.254.2
PoE gateway: 192.168.254.1/24
Home router: 192.168.1.1/24
so, static route has to between 192.168.1.1 and 192.168.254.1?
Can I just do a static route between...
Hello all, I have my DS-KV6113 Doorbell connected behind my NVR (so it can also record to NVR) but i cannot get the doorbell to ring. It always says "calling failed". I have my push notifications enabled on the app, but i have a feeling it has something to do with communicating out of the POE...
So the Doorbell camera works and all. Video, Calls Phone, records to NVR, etc
but when button is pressed and I answer the phone to see who it is, the video feed comes up as “Network Unstable” but the 2 way audio works and buzzer (if it existed) works as well
everything is hardwired, Not...
Yes, DB Camera went back to inactivate after it accepted the firmware. TFTP and/or telnet did nothing. Only option was the SD card slot. Was easy and worked flawlessly
Disregard! Worked with just uploading the digicap.dav firmware onto a blank SD card, inserted it into the doorbell camera, powered it up, and boom! Uploading! apparently the upload deactivates everything (good in my situation) but could be a potential security flaw because outside has access to...
Hello, I accidentally loaded old or incompatible firmware to my KV6113 Door Bell. May have been version A or something, i dont know. But after the upgrade (well, downgrade) I am unable to log into the device. Yes, I am able to access a login screen but my set password (and other potential...
Hey, I also bricked my doorbell because I loaded older firmware. Will attempt to load onto an SD card and see what happens. does anyone have a firmware link? I am unable to find any 200804 or younger firmware.
Thanks