"Configuration > Intercom > I/O Settings, "Output" should have a dropdown allowing you to switch between "Electric Lock" and "Mechanical Doorbell". "
Reached a dead end as the above option of I/O settings is missing..:(
Hi JB
Thanks for the comprehensive reply !
I will check the configuration and report back. I am currently using the NO for a door lock which is working fine. So really it may be a dead end if I can't get any other wires that can trigger the relay when the bell is activated.
Hi JB
Sorry to jump on your thread but I am trying to wire the KV6113 to an existing doorbell running on a 220V supply using a 12v relay.
Basicly looking for the two wires in the KV6113 bell to trigger the 12v relay whenever the KV6113 is pressed so that it rings the additional bells in the...
Using TFTP with serial cable attached to a 4 pin header on the main board. Console activity is accessed by PUTTY.
SADP or WEBGUI do not pick up the DVR.
The firmware flashes fine, as long as it is the correct one. After flashing and reboot the putty console displays the final line
insmod: can't...
I am also using the commands below; maybe they are not correct for this DVR
setenv ipaddr 192.0.0.64
setenv serverip 192.0.0.128
setenv bootargs console=ttyS0,115200n8 root=/dev/ram0 rw initrd=0x42000000 init=/bin/sh
setenv bootcmd 'tftp 0x42000000 uImage; update'
I tried that and it flashed OK, however, the problem is still there. previously it failed with tp2823 file, this time its the directory
hdal_base: 0xc000000, hdal_size: 0x34000000
loadAd tp2823:0, tp2833C:0, tp2827C:0, tp2828:0, tp2831:0, tp2830:0, nvp6134:0, nvp6134b:0, reg_fe:0, reg_ff:0...
Tried that firmware and its not accepted by the DVR, as shown below.
It appears not to be compatible, whereas the one I was using flashes OK, however, the DVR does not load.. as indicated in my first post..
This program will download and upgrade software...
id-7208HUHI-K1/4S(B) updated with DVR-K8A3_EUROPE-ML_STD_V4.26.131_210811.
Update was OK error in loading shows insmod: can't insert 'extdrv/tp2823.ko': No such file or directory
***
ATTENTION!! PLEASE READ THIS NOTICE CAREFULLY ! *
Don't power off or anything that interrupt it ! *
The upgrade...