Recent content by Tricky

As above originally my Tapo wifi cameras were not visible at all until several reboots, now I have added them to the DVR, but cant add or see them via iVMS 4200 on my PC or mobile app any ideas?

Well finally got them back after rebooting both cameras a few times so have now added them to the DVR but still can't add or see them on the mobile app.

Anyone? Maybe i should have put this in the IP camera section?

Strange problem, I fitted a new router and this basically shifted all the LAN IPs for my Hick vision cameras and DVR, should have made them static I know but due to drop out problem the router was removed, and the old one replaced and all the LAN IPs reset but still cant see the DVR camera...

Don't go into the NVR menu often (NVR is DS-7608-NI-K2.) so may have forgotten something, aside from three Hikvision colorvu cameras via POE i also have two Tapo wifi cameras that were connected and showing on both the HDMI NVR and mobile Hikvision app but suddenly lost the most recent one now...

I am actually using the IVMS phone app as opposed to the IVMS PC software i know you can do more but it so clunky and slow and will sometimes cause my laptop to lock or really lag , Its not new but not new and I5 processor and 8 gig of ram i thought it would handle the IVMS software a bit better...

Why is the PC version of the Hickvision software so much faster and easyer than the PC version? the PC version is so much slower clunkyer and a PITA to use? i just got a new phone a becasue my old phone was just that i never bothers to load the phone app but now its my preferred option when...

Didn't want to do a full reset as its a lot of resetting everything up, and hadn't seen the light turn off and on for quite a while then last night i put the bin out and saw the same camera turn off and on sever times in a row checked the recordings for the same time in the last four days...

The case fan does produce noise mainly because of the case perforations coursing turbulence but i changed that one to a other brand and dont really find it too bad its the power supply fan that's the problems but after changing to a Noctua i dont find it a bothers me but my NVR is in a cabinet...

Mine is also no powering via POE so I fitted a Noctua 20x20x40mm fan to mine and its much quieter but you will need to find a two pin plug to fit the NVR if you want to be able to refit the old fans at some point for any warranty issues.

Thought you said it was fixed?:confused::confused:

Yes i had this issue its easy to click on the screen and loose the live feed if you not too familiure with the system control or just set up it a little convoluted and over complicated IMO.

I use ColorVu cameras and cant fault them they reveal much more detail being colour at night than the previous IR cameras i have used...although that was a few years back so may well be better these days.

Just tried the format you mentioned but the stream wont open but i haven't configured the router and just used the port used in the Hikvision software con-fig screen.

Thanks but wont that mean i will have to reconfigure the NVR as all cameras are connected via POE switches through the router to NVR?