Recent content by Yupowert

Just to add, that except for displaying the Channel-Zero stream (if you have it enabled), I'm fairly certain that on a local network, iVMS connects directly to each camera, not via the NVR. I have the Channel-Zero stream active, as it gives an assurance of what the NVR is actually recording...

... and for those of you who can't wait... here's a snipping from the PDF... Yeah, Hikvisions changelog fix lists are awe inspiring...

hmmm... are you describing something different to the behaviour shown in my picture below? Creating these irregular shaped go/no-go motion zones has been available for years. I've not upgraded my units yet (and won't be for some months), so I'm interested to see if this interface has changed at...

I have a both a laptop & ipad with a 4G card, and WiFi, with the iVMS/Connect clients installed. For me, if iVMS figures out it is on the same local network/subnet as my cameras (i.e when I'm connected using the LAN Wifi), it will connect to them in 'HD' (aka main stream). If not, (e.g I'm out...

The ultra-uber-super-in depth release note can be found here: https://www.hikvision.com/content/dam/hikvision/en/support/download/firmware/nvr/k-series/k1(b)/release-notes/K74_-Lite-V4.30.060-build201228_release_note.pdf Just be prepared for the mind bending detail it goes into...

My wrote my post before the new K2 specific v4.30.005 E-IU firmware was released, so it's actually a bit redundant now. However, at the time, I simply downloaded the standard I-series firmware, V4.40.015 build200616 , and did a local update via the browser interface onto my factory default...

I believe those settings (and many others) are stored within the cameras themselves. The NVR only reads the values, displays them on the screen, and requests the camera saves changes when you click save. So a factory reset on the NVR would simply delete the camera from the list. You'd need to...

I'll keep you (all) posted ! (In a few weeks when I do my other 7616-K2/1P So far 11 Cams, (8x2MP 3x4MP, - 9 hardwired, 2 WiFi) (None are PTZ or Audio) all working fine. Web interface great (Not using the direct interface). Basic Motion Event detection setup and working. Playback of all cams...

I don't know whether it's THE SAME firmware, but it's certainly compatible - how much, and whether there's any underlying long term issues/incompatibilities, well that's for each individual to find out. It's not recommended/promoted/claimed/suggested or mentioned by Hikvision, but others have...

I've just installed it 48 hrs ago directly onto my new second DS-7616NI-K2/P1 - and it's working great. No crashes etc. As it is a new unit, I did a factory reset and camera import after upg. For me, even though I only use it via the web interface, I immediately see 2 advantages 1) I can use...